The product is an B rated voltage 1140V and below the AC rated voltage, and the electrical winding is connected with the electric appliance winding and leads to the casing or the winding and the connection column of the motor shell. Has a good flexibility and heat resistance, solvent resistance, especially suitable for hot and humid areas.

1, the conductor of the tinned copper wire, the provisions of its structure in accordance with the following table, performance in line with the JB947-76 the rubber and plastic insulated copper wire and cable conductive wire core "requirements; 2, insulation rubber performance in line with the JB664-77 the wire and cable with rubber" standard provisions; the provisions of insulation thickness in accordance with the following table, allowing deviation of 10%, the thinnest thickness of not less than 90%-0.1mm nominal value of;

3, sheath rubber performance in line with the JB664-77 "wire and cable rubber" standard; jacket thickness in accordance with the following table, allowing the deviation of -20%, the thickness of the thickness of not less than 80% of the nominal value;

4, finished wire must withstand the OYYDDL0118-2003 specified AC 50Hz resistance voltage test;

5. The direct current resistance of the finished wire and conductor wire should conform to the requirements of Table 1 and 2 when the temperature is 20;

6, wire should be able to withstand leaching paint test, cable after 130 plus or minus 5 DEG C, 5 hours of constant temperature, immersion temperature for 50 plus or minus 5 DEG C of 1032 paint for 30 minutes, remove the drip dry, then the 130 plus or minus 5 DEG C, 48 hours of constant temperature. Finally, the electric wire is wound on the provisions of the diameter of the rod, wire sheathing layer should be no cracking and brittle fracture and sticking phenomenon.